1. Verify that the number of joints in the product cross - sectional cutting faces matches what you've made.
2. Adjust the EPC device as per the semi - finished product's characteristics. Ensure the EPC photoelectricity tracks properly. Hold one end of the film and slowly open the slitter to guide the film into position.
3. Press the stop button to halt the machine. When unloading, keep hands away from the rewinding shaft to prevent finger injuries.
4. Start the machine slowly. Check the slit film's quality, then gradually increase speed. Never put hands into the running slitter to avoid hand injuries.
5. Adjust the raw material rack's max-width='100%' width. Place the semi - finished product film roll on it. Keep hands away from the film roll's cross - section during loading. Allow only one - person operation to prevent hand injuries from the cylinder.
6. Center the photoelectricity. Keep the unwinding table's slider in the correct middle position on the guide roller.
7. Mount properly - sized paper tubes on the rewinding shaft. Wind the slit products onto the paper tubes on the upper and lower rewinding shafts as usual. Start the machine slowly to find the right position for the paper tubes on the rewinding shaft and mark it for future use. Hold the paper tubes firmly when installing them to prevent them from slipping and causing shaft - related injuries.
8. Guide the slit film to the rewinding shaft as required. When threading the hot - melt adhesive machine, ensure no blades are on the machine to avoid cuts.
9. Install the slitting knife frame in the proper position per the task order. Tighten the lower knife, then start the machine slowly to slit the semi - finished products to the required size.

10. Power on the slitter. Set parameters like unwinding/winding tension, counter auto - stop number, and material thickness as per the task order. Then activate the photoelectricity.

http://www.paperslitter.com/productdetail/turret-type-label-slitting-machine.html