1. Machine Assembly: When a slitting machine is uninstalled, its components are typically separate. After selecting a site, position the front, rear, and middle frames on a level surface to align them on the same horizontal plane and ensure stable operation.

2. Initial Testing: Once all parts are installed, power up the machine for testing without loading materials. Monitor the components' operation and power off immediately if any abnormalities occur.

3. Safety Procedure: Disconnect the power supply when the slitting machine is not in operation.

4. Pre - Operation Inspection: After installation, inspect and service the machine's components, including chains, sprockets, bearings, and reducers, by applying lubricating oil or grease.

5. Component Debugging: After lubrication, debug the main components to ensure smooth rotation without blockages.

6. Site Selection: Install the slitting machine on a level, hardened surface. An uneven floor can cause component misalignment during operation, leading to sub - par production quality.

http://www.paperslitter.com/productdetail/high-speed-film-slitting-machine.html